Connecting copper - solder (page1)

Since these involve the use of a blowtorch, make adequate provision for the prevention of fire. Never allow the flame to point towards combustible items. Be extra vigilant when working in confined areas. Use a protective mat behind the area being heated to reduce the spread of heat.

There are two types available. Standard end feed and the integral solder type.

Preparing the joint

Cut and test assemble the piece first. Once this has been done, soldering of the joint may be started. But, remember that both ends of a joint will need to be soldered at the same time. If you try to heat the second end of the joint, after the first has already been completed, the heat will re melt the solder on the first, causing the joint to fail.

All parts of the copper to be soldered need to be completely clean to ensure a good bond. Use wire wool to remove dirt and grease and continue a little to remove the oxidation on the pipe. You should now have shiny ‘new penny’ looking ends.

Applying flux

Apply some flux to each surface of the joint. This is a paste which prevents further oxidation and assists the flow of solder. Application is easiest using a small craft brush – one of the really cheap ones since it will be useless for any other purpose afterwards.

Assemble the solder joint

Reassemble the joint giving each part a twist back and forth to spread the flux.

Now line up the assembly so that every component is in the right place. The shape and direction of the pipe must be as you originally intended since no adjustment will be possible after the connection has been completed. Obviously, with a straight joint there will be no problem but, when assembling bends and junctions, it is easy to do a beautiful job of the joint only to find the direction of the pipe has moved a little out of line.

End feed solder joints

You will require a reel of suitable solder and should unroll a little so that it can be applied without getting your hands too close to the heat.

Light the blowtorch and allow it to burn for a minute or two. This allows the nozzle to heat up, which seems to reduce the chance of the flame flaring up when the torch is tilted.

Gently and evenly apply heat to the whole joint. As soon as the flux begins to bubble, remove the heat source and touch the solder at several points around the ends of the joint. Capillary action will draw the solder in between the pipe and the joint. Apply enough solder so that you see a complete ring of it around the mouth of the fitting. Allow the joint to cool.

Continued...

• Compression joints
• Copper pipe
• Cutting pipes
• Securing pipes
• Bending pipes